6096 Deep Groove Ball Bearing (480x700x100mm)

How to read this designation →

Bearing dimensions and basic technical information.

Schematic of an open single-row deep groove ball bearing with a pressed steel cage

Schematic only — for the actual construction, refer to each manufacturer's information.

Bore diameter (d)480 mm

Outer diameter (D)700 mm

Width (B)100 mm

TypeDeep Groove Ball Bearing

RowSingle Row

ClearanceCN

Cage

Material Steel

Manufacturer Ratings

Load-rating symbols are printed as each manufacturer writes them in its own catalogue, so the same quantity can carry a different symbol from brand to brand.

BrandDynamic Load RatingStatic Load RatingFatigue Load Limit
SKF 6096 MBC618 kNC01140 kNPu20 kN
NSK 6096Cr665 kNC0r1090 kN—

Speed Ratings

Speed limits depend on sealing and lubrication, and definitions differ by manufacturer. Contact-sealed variants are normally greased for life and run slower. Always confirm the exact variant in the manufacturer's table.

BrandGrease
open / shielded		Oil
open		ReferenceLimiting
SKF 6096 MB——1,700 r/min1,400 r/min
NSK 6096710 r/min850 r/min——

References

  1. SKF — SKF Group, Rolling Bearings, PUB BU/P1 17000/1 EN, Oct. 2018.
  2. NSK — NSK Ltd., Rolling Bearings for Industrial Machinery, CAT. No. E1103, Tokyo, Japan, Jan. 2025.

Related Bearings

Bearings with the same boundary dimensions (480 × 700 × 100 mm), across types and variants.

Deep Groove Ball Bearing6096 MB (SKF)
Cylindrical Roller BearingNJ1096 | NU1096

Related Guides

6204 vs 6304: Same Bore, Different Capacity6204 and 6304 both fit a 20 mm shaft, but the 6304 carries roughly 20% more load. Compare dimensions, load ratings and speed limits — and learn when the heavier series is worth it.Bearing Basics: What Bearings Do and How to Use This SiteNew to bearings? Learn what a bearing does, the parts it is made of, and how to find your way around Berolix.How to Measure a Bearing: Bore, OD and WidthHow to measure a bearing with calipers: bore, OD and width — then turn three numbers into the right designation.How to Read a Bearing DesignationDecode bearing numbers like 6204-2RS or 6210/C3: type codes, dimension series, bore codes, and the most common prefixes and suffixes.Load Ratings Explained: What C, C0, Cr and C90 Really MeanBasic dynamic and static load ratings are ISO quantities, but every manufacturer prints its own symbols. A brand-by-brand guide to C/C0, Cr/C0r, Ca/C0a, Ce/Co and Timken's C90 — plus the C0 versus Co glyph trap.

Disclaimer: Data on this page is compiled from publicly available online sources for reference only, and not every model appears in a manufacturer's published catalog. Values may differ between sources and editions — always verify against the manufacturer's current documentation before design or purchase.Full disclaimer →